Is there a trim command in Revit?

Use the Trim and Extend tools to trim or extend one or more elements to a boundary defined by the same element type. You can also extend non-parallel elements to form a corner, or trim them to form a corner if they intersect.

How do you trim a model line in Revit?

Trim/Extend Single Element:

  1. Go to Modify Tab -> Modify Panel -> select Trim/Extend Single Element.
  2. Click the face of the the middle vertical wall as the boundary for trimming.
  3. Click on any point on the part of the horizontal wall that you would like to KEEP (not trim) – in this case, left of the vertical wall.

How do you cut a line between two lines in Revit?

click Modify tab Modify panel (Trim/Extend Multiple Elements). Select the reference to use as a boundary. Then select each of the elements to trim or extend. For any elements that cross the boundary, the part that you click is retained.

How do I make baseboards in Revit?

Use the Sweep tool to add a baseboard, crown molding, or other type of decorative horizontal or vertical projection to a wall. Open a 3D or elevation view containing the wall to which you want to add the sweep. Click Architecture tab Build panel Wall drop-down (Wall: Sweep).

IT IS INTERESTING:  What specs are important for AutoCAD?

How do you round floor edges in Revit?

On the Properties palette, click the Curved Edge Condition button located under Structural Floor Shape Edit. This opens the Curved Edge Condition Dialog. Select either Conform to curve for a scalloped surface, or Project to side for a flat surface. Click OK to apply the condition.

How do you cut extrusions in Revit?

Solution:

  1. Edit the in place wall.
  2. Create a new void extrusion that will define the opening.
  3. Use the “Cut” tool and select the void geometry.
  4. Finish the solid edition.

How do you split in Revit?

Split Elements

  1. Click Modify tab Modify panel (Split Element).
  2. If desired, on the Options Bar, select Delete Inner Segment. When you select this option, Revit removes the segment of the wall or line between selected points.
  3. Click the element at the point you wish to split.

How do you insert a line in Revit?

To Join Polylines, Splines, Lines, and Arcs Into a Single…

  1. Click Home tab Modify panel Edit Polyline. Find.
  2. Select a polyline, spline, line, or arc to edit. …
  3. Enter j (Join).
  4. Select one or more polylines, splines, lines, or arcs that are located end to end.
  5. Press Enter to end the command.