What is the use of reference plane in Revit?

Contents show

Use the Reference Plane tool to draw reference planes to use as a guideline in your design. Reference planes are an integral part of family creation. Reference planes display in each plan view that you create for a model.

How do you add a reference plane in Revit?

Add a Reference Plane

On the Draw panel, click (Pick Lines).
On the Options bar, specify an offset, if desired.
Select the Lock option to lock the reference plane to the line.
Move the cursor near the line to which you want to place the reference plane and click.

What is the difference between reference plane and reference line in Revit?

What is the difference between reference planes and reference lines? A Reference Plane is an infinite plane that servers as a guide for drawing lines and geometry. A Reference Line creates a line similar to a reference plane, but that has logical start and end points.

What is use of reference plane and write its types?

In celestial mechanics, the plane of reference (or reference plane) is the plane used to define orbital elements (positions). The two main orbital elements that are measured with respect to the plane of reference are the inclination and the longitude of the ascending node.

IT IS INTERESTING: How do you subtract a Boolean in SolidWorks?

What are the different types of reference planes?

1.1 shows the three standard reference planes: the medial (mid-sagittal), the frontal (or coronal), and the transverse planes, all at 90 degrees to each other and usually set to meet in the center of mass of the whole body.

What is reference line?

Reference Lines allow you to place lines on the plot at specific locations to mark important values. You could use these to mark control limits or to indicate a trend line for a set of data.

What is a reference plan in Revit?

Where is reference line Revit?

In the Family Editor, click Create tab Datum panel (Reference Line). Using the drawing tools, sketch the line. The line displays as a solitary solid line until selected or when highlighted during preselection. When selected or highlighted, the associated planes display according to the active view.

How do you create a work plane in Revit family?

In the Family Editor, click Create tab Properties panel (Family Category and Parameters). In the Family Category and Parameters dialog, under Family Parameters, select Work Plane-Based. Click OK. Note: You can make a family both work plane-based and always vertical.

How do I delete a reference line in Revit?

To remove reference points for a permanent dimension, delete their witness lines.

Select a permanent dimension.
Right-click the blue control in the middle of a witness line, and click Delete Witness Line.

IT IS INTERESTING: You asked: How do I remove a panel from a curtain wall in Revit?

What is profile plane?

Profile plane of projection. In multi-view drawings, the right side view is the standard side view used. The right side view of an object shows the depth and the height dimensions. The right side view is projected onto the profile plane of projection, which is a plane that is parallel to the right side of the object.

What is the use of reference axis?

A reference axis is commonly called a “half-axis”. Reference axes are typically used for monitoring some quantity, such as: Position. Velocity.

What is use of reference plane and write its types in Solidworks?

Reference planes were added to facilitate an extruded cut on a non-planar face, and a temporary axis was used to align the rectangular sketch properly. Finally, a new coordinate system was created to determine the coordinates of the center of mass from a relative location.