How do you do cut fill analysis?
This method involves drawing horizontal and vertical lines over your site plan to divide it into grid cells of equal size. You then include the existing elevation and proposed elevation for each corner of the grid cells, and work out the difference between the two, as this will be cut or fill depth for that spot.
Is cut and fill expensive?
Costs. Builders say that putting a concrete slab on a cut and fill site is cheap, and it is until you factor in extra costs to solve the drainage problems that occur after the builder has long gone. Putting in drainage after completion of the home is very expensive.
How do you get volume in Revit?
Click Architecture tab Room & Area panel drop-down (Area and Volume Computations). On the Computations tab of the Area and Volume Computations dialog, under Volume Computations, select (to enable) or clear (to disable) Areas and Volumes.
How do you calculate fill area?
Rectangular Area
- Measure the length, width and depth of the area you want to fill with dirt. …
- Calculate the volume of dirt needed to fill the area you measured by multiplying length (120 inches) by width (60 inches) by depth (30 inches). …
- Convert cubic inches to cubic yards by dividing by 46,656 cubic inches.
How do you get cut and fill volume in Civil 3D?
Solution:
- In command line type “COMPUTEMATERIALS”.
- Select the alignment and sample line group to sample, then click “OK”.
- Change “Quantity takeoff criteria” to “Cut and Fill” or other desired criteria.
- Map the sampled surfaces to the correct object names, then click “OK”.
How do you calculate earthwork?
To calculate the earthwork estimate requires multiplying the area by the difference between the average of two sets of levels. Formula: Volume = Area * Difference between the average of two sets of levels.
Why do we need to know the mass diagram?
Mass diagrams indicate the spatial relationship between excavation (cut) and embankment (fill) on a project and are good tools in planning for efficient earthwork operations. The basic excavation and embankment volumes and locations must be known before the mass diagram can be constructed.
How do you calculate earthwork volume?
A common method of determining volumes from cross sections is that of average end areas. It assumes that the volume between successive cross sections is the average of their end areas multiplied by the distance between them. This is expressed in the formula: V (Ft.