How do I turn off Snap to Grid in Catia v5?

As for the textbox, the snap to grid option can be turned off by hitting shift. Alternatively you can disable it at option>mechanical design>drafting. Click on the “annotation and Dress-up” tab and unclick snap by default to disable it permanently.

How do I turn on grid in Catia?

This page deals with the Grid capability.

  1. To display the Grid in the Sketcher session, just click Grid in the Sketch tools toolbar. The grid is displayed. …
  2. Select Tools > Options … …
  3. Select the Mechanical Design category in the left-hand box.
  4. Select the Sketcher sub-category. …
  5. Set the options according to your needs:

How do you change the grid spacing in Catia?

To set the grid click Tools – Options and, under Options click Mechanical Design – Drafting and then select the General tab. 5. In the Grid settings, check the Display option if it is not checked. For Primary Spacing enter 50 mm and for Graduations enter 5 mm.

What technique should be used to turn snap grid off?

Note: Snap mode can be turned on and off with the F9 key. You can suppress snap temporarily by holding down F9 while you create or modify an object.

IT IS INTERESTING:  How do you hide flow simulation in Solidworks?

How do I get rid of Snap to Grid in Catia?

As for the textbox, the snap to grid option can be turned off by hitting shift. Alternatively you can disable it at option>mechanical design>drafting. Click on the “annotation and Dress-up” tab and unclick snap by default to disable it permanently.

How do you draw a construction element in Catia?

Click Standard/Construction from the Sketch tools toolbar so that the elements you are now going to create be either standard or construction element.

How do I change units in Catia?

change the units in catia V5: Tools-> options->parameters and measures->units.

How do I change the default units in Catia?

3DCS follows the CATIA units. The default unit is millimeters. To change the units, simply click the drop-down list at the bottom of the units window and select the desired unit.