First Test (Get parts done by June 25 – 8 working days left)
Full Test (Get parts done by July 19 – 24 working days left)
Anchors (pyramids) (2 by June 25 and 16 by July 19)
Sent out board that Gregg made (60 pieces for $244)
Ordered parts for Davie’s board (ordered 16 of each from Digikey, except for terminal block, only 5 available). Also got 200 miniusb recepticals and 100 pin switches, which were very hard to find and used in several designs.
Decided to rapid prototype two for the June deadline and manufacture 17 others for July. Howard is working on a fixture for the odd angles.
Ordered enough acrylic for a few, to make sure we’ve got the right stuff. Should be here 6/16
Cut acrylic
Phil ordered screws today.
Still need to send in order for prototyped parts.
Anchors (beds) (4 by June 24, 35 by July 19)
Tim’s going to design the boxes based on the door minder design
– Need to check on how that is going
Had trouble with the in-hospital test yesterday — think it’s a wiring issue. Will wait to buy antennas until it is resolved. Parts ordered.
Buy antenna adaptors – waiting on new antenna tests.
Buy antennas
Buy antennas wire
Gregg found that we can get 5 wall->USB adaptors from the electronics shop for $4.95 each. The electronics shop has ordered those and order 30 more from them.
Gregg will check on power pack (3V) and a outlet->USB convertor. We have a prototype battery pack built. Need to order more black boxes to hold them.
Badges (20 by June 24, 100 by July 19)
Secure 100 badge shells – Done.
Find out what was wrong with the old badges – Checked broken badges over the weekend. 3 of 4 had broken wires, which I fixed. We’ve soldered the wire to the boards which is not as good as a connection. Not much room, but I’ll see if there is another way.
Order boards (Main plus daughter)
Order batteries (Replacement for Ipod mini, Model No EC003, 3.7VDC 850mA)
Order parts: Ordered 80 MAX1555 chips from Newark. Have a parts list ready for digikey. Just need to double check the list.
Sherlock connectors, 3 pin, right angle (these are in the digikey order)
Face plate. Electronics shop (Tim?)
Screws?
Cut wires
Make boards
Pucks (12 by 6/25, 75 by 7/19)
Test latest design 14th and 15th
redesign for manufacturing – Mostly done. Howard is preparing to manufacture them when the plastic arrives.
order machining raw stock – done
order boards from external supply house – Need to look over board to see what we want to do.
order parts from digikey for boards
order hardware (screws and spacers)
build boards
machine parts
assemble
test
Door minders (4 by 6/25, 35 by 7/19)
Test new boards 14th 15th
Write program to write to flash
Ordered 50 transmitter and receiver chips from Reynolds Electronics
Ask Phil to make a couple more (maybe revisions)
Resolve channel selector switch issue with Tim
Make 4 with parts on hand and boards made by Phil
Talk with Tim about the getting the bodies made
——– Enough for 4 prototypes ————-
Send final board to board house (here by July 21)
Figure out how to manufacture body (finish by July 21)
Order components (all here by July 21)
Assemble boards (perhaps 1/2 hour each)
Through hole soldering
Cut wires
Assemble mechanical parts
Test
